|Audi S4 Car Audio - Bose Enclosure and Speaker Removal|
|Audi Car Stereo Removal|
Installing Aftermarket Speakers and Proper Hook-up
With aftermarket stereo installation?
|Erratic Volume Control
|How to Front Door Panel Bose Speaker Enclosure Removal|
Front Speaker Removal and Replacement
|1.1) Remove one screw at back of door panel.|
|2.1) Remove one screw at front of door panel.|
|3.1) Remove arm rest handle cover by finding the small hole underneath, placing a small screwdriver in the hole and pull it towards you at the same time. The cover will unsnap at the bottom. Gently pull the cover out and it will unsnap from the middle and top as well.|
|4.1) Remove the two screws from the arm rest handle which are exposed from the arm rest handle removal.|
|5.1) Door handle should now be easily pulled out to expose
the cable and hook.
5.2) Remove silver clip securing cable to the end of the door handle assembly.
5.3) Take careful note of the position of the cable retainer within the handle assembly so that you can reassemble correctly, then remove cable from the retainer.
|6.1) Cable should now be attached only by the hook into the
door handle. Take note on the direction the hook is facing for reassembly. Turn the handle
as mush as possible and bend cable slightly with needle nose pliers to release hook.
6.2) Door handle will be attached with wires, Rear door panel handle is hard wired an is feed through panel opening when removing.
Front door panel has a connector which may be released.
Front Door Panels Only
7.1) Remove hidden screw through opening in vinyl from door latch panel removal.
|8.) Remove door panel from door by lifting up at bottom one
to two inches to release door hooks.
8.2) Move panel out and over the manual door lock button.
8.3) Disconnect all connectors holding panel to door.
9.1) Remove six screws securing Bose enclosure with amplifier and speaker to door panel.
*NOTE - Watch these clips (hooks) when reinstalling.
|Audi Bose Amplifier Removal, Repair and Replacement|
|1) Bose amplifier is located in trunk.
2) Remove screws securing unit to center/bottom of package shelf.
3) Disconnect connecters.
|See our Shipping page and Free Repair Estimates.|
Factory Car Stereo Repair, Inc.