Audi TT Car Audio - Removing Car Stereo and Speaker


Audi TT
How to Remove Car Stereo

Mercedes, Audi, Land Rover, Porsche, and others Car Stereo Removal Tool
Slotted Din Tools

   
Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up
   
NO AUDIO
With aftermarket stereo installation?
   
Erratic Volume Control
DIY Repair
   
Audi TT How to Remove and Replace Front Door Speakers
Audi TT Car Radio Service, How to Remove and Install Speaker Front Door Speaker Removal and Replacement
1.1) Grasp silver medallion at arm rest.
2.1) Twist counter clock wise to unlock.
3.1) Remove and set to side.
4.1) Remove exposed Torx T-30 screw.
5.1) At top front edge of door panel, pry rubber edge of insulation from door panel releasing securing tabs into door panel.
6.1) Pry along edge of rubber insulation releasing second tab.
7.1) Lift bottom edge of insulation up to release tongue from groove.
7.2) Pull insulation back verifying all tabs are released from door panel.
8.1) At top back edge of door panel, pry rubber edge of insulation from door panel releasing securing tabs into door panel.
9.1) Pry along edge of rubber insulation releasing second tab.
10.1) Pry along edge of rubber insulation releasing third tab.
11.1) Pull insulation back verifying all tabs are released from door panel.
12.1) Grasp door handle and lift door panel up out of window jam to release door panel from door.
12.2) Pull top edge of door panel back for access to back of door panel.
13.1) Locate wire harnesses and connectors on door panel to control panel.
14.1) Fold edge of door panel insulation back for access to connectors.
15.1) Locate connector locking trigger on connector.
16.1) Lift trigger on top of connector up to release lock.
17.1) Remove connector.
18.1) Lift trigger on top of second connector up to release lock.
19.1) Remove connector.
20.1) Lift triggers on sides of third connector up to release lock.
21.1) Remove connector.
22.1) Lift triggers on sides of fourth connector up to release lock.

23.1) Remove connector.

Note - Passenger's door has less connectors.

24.1) Locate door handle cable.
25.1) Door handle cable is secured to door panel.
26.1) Pull securing base of cable from door panel to release.
27.1) Twist end of cable to release hook on cable from assembly.
27.2) Remove door panel and set to side.
28.1) Door panel is secured to door with hooks along edge of panel.
29.1) Hooks secure door panel to door along edge of door.
30.1) Remove screws on back of door panel securing speaker and remove.
31.1) During reinstallation of door panel, rubber insulation guides onto door.
32.1) Push tabs into place on door panel to secure.
   

Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact US

Factory Car Stereo Repair, Inc.
1987 Corporate Square, Suite 159
Longwood, Fl. 32750