Do It Yourself La Sabre Car Stereo Removal and Install
Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
   
Buick La Sabre Car Stereo Installation, Removal and Replacement

Buick La Sabre
How to Remove and Install Car Stereo Removal

Buick La Sabre Car Stereo Installation, Removal and Replacement 1.1) Open glove box and remove two screws from along top edge.
Buick La Sabre Car Stereo Installation, Removal and Replacement 2.1) Gently pry trim panel from across dash releasing clips and set to side.
Buick La Sabre Car Stereo Installation, Removal and Replacement 3.1) Gently pry left side trim panel from dash releasing clips.
Buick La Sabre Car Stereo Installation, Removal and Replacement 4.1) Place steering column in down position.
4.2) Remove hidden screw behind rubber boot next to steering column securing gauges trim panel.
Buick La Sabre Car Stereo Installation, Removal and Replacement 5.1) Remove one screw from right side of trim panel.
Buick La Sabre Car Stereo Installation, Removal and Replacement 6.1) Pull trim panel from dash releasing all clips
Buick La Sabre Car Stereo Installation, Removal and Replacement 7.1) With fingers, push spring securing clips on both sides of car stereo inward toward car stereo and pull car stereo from dash.
Buick La Sabre Car Stereo Installation, Removal and Replacement 8.1) This is the "Dock and Lock" system, car stereo releases from all connector when pulled from dash, disconnect antenna.
   
Factory Wire Color Codes
See Diagrams Below
   
Aftermarket Wire Color Codes
See Diagrams Below
   

Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up

Speaker Phasing
Font Left   Front Right
+ Tan   + Light green
- Gray   - Dark green
     
Rear Left   Rear Right
+ Brown   + Dark blue
- Yellow   - Light blue
   
NO AUDIO
With aftermarket stereo installation?
   
Buick LaSabre - Wire Diagrams - Wire Color Codes
Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
 
Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn.
DO NOT CUT FACTORY WIRE HARNESS
   
Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above.
We discourage cutting the factory wire harness.
This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons.
Diagrams may not be applicable to Bose Audio Systems
   
GM Wire Harness Diagram, Wire Color Codes and Pin Configuration Wire color codes and wire diagrams
IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts.
1   Gray Left Front Speaker (-)
2   Tan Left Front Speaker (+)
3   Dark Green Right Front Speaker (-)
4   Light Green Right Front Speaker (+)
5   Black Ground
6   Brown Illumination
7   Gray Dimmer
8   Blank  
9   Yellow* (Green) Switched +12 volts
10   Orange Constant +12 volts
11   Light Blue Right Rear Speaker (-)
12   Dark Blue Right Rear Speaker (+)
13   Yellow Left Rear Speaker (-)
14   Brown Left Rear Speaker (+)
   
All wire diagrams and color codes are not 100% accurate.
   
Front and Rear Speaker Removal presently not available.
   

Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us

Factory Car Stereo Repair, Inc.
1987 Corporate Square, Suite 159
Longwood, Fl. 32750