1.1) Gently pry panel insert from center
console and disconnect connector.
2.1) Lift center console top insert up
releasing clips and remove.
3.1) Remove two screws from center console.
3.2) Remove rubber insert from bottom of arm rest cavity and remove two
4.1) Remove one screw on passenger side of
car from bottom of side panel.
5.1) Remove fuse panel cover from side of
6.1) Pull bottom side panel forward releasing
clip and remove.
7.1) Remove one exposed screw from panel on
passenger side of car.
8.1) Release plastic tab on drivers side of
car at bottom of panel next to hood release.
9.1) Remove one screw at bottom of panel on
drivers side next to center console.
10.1) Set parking brake, shift to low gear.
10.2) Surrounding assemble around gear shift has spring suspension, push down
on forward edge while pulling center console toward back of car. For small
clearance from dash.
11.1) Pull left side panel toward back of car
releasing clips and set toward floor.
12.1) Gently pull entire dash trim from dash
and around car stereo
12.2) Remove panel from car.
13.1) Remove screws securing car stereo to
13.2) Pull car stereo from dash, disconnect antenna and connectors.
Factory Wire Color Codes
See Diagrams Below
Aftermarket Wire Color Codes
See Diagrams Below
Installing Aftermarket Speakers and Proper Hook-up
Aftermarket stereo installation?
Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver!Factory wire colors codes are not universal. See Aftermarket Videos above.
We discourage cutting the factory wire harness.
This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons.
Diagrams may not be applicable to Bose Audio Systems
IMPORTANT - There are two (2) yellow*, two (2) gray and two (2)
brown wires in this harness. Locate the +12 volt constant wire first.
Label it or splice to constant wire on aftermarket stereo first. Swapping
yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts.
Left Front Speaker (-)
Left Front Speaker (+)
Right Front Speaker (-)
Right Front Speaker (+)
Switched +12 volts
Constant +12 volts
Right Rear Speaker (-)
Right Rear Speaker (+)
Left Rear Speaker (-)
Left Rear Speaker (+)
All wire diagrams and color codes are not 100% accurate.
Rear Speaker Removal and Replacement presently not available.