Chevrolet Aveo Remove and Install Stereo and Speakers
Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
   

Chevrolet Aveo
How to Remove, Replace and Install Car Stereo

Car Stereo Radio Code
(Daewoo)

   
Factory Wire Color Codes
See Diagrams Below
   
Aftermarket Wire Color Codes
See Diagrams Below
   
Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up
   
NO AUDIO
With aftermarket stereo installation?
   
Erratic Volume Control
DIY Repair
   
Chevrolet Aveo Front Speaker Removal and Replacement
Car Stereo Repair
| Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
How to Replace Speakers, Removal and Install

Chevrolet Aveo
How to Remove and Install Front Speakers

How to Install Speakers, Removing and Replacing 1.1) Remove two screws along bottom edge of door panel.
How to Replace Speakers, Removal and Install 2.1) Remove one screw along front of door panel.
How to Install Speakers, Removing and Replacing 3.1) Gently pry small cover from arm rest.
How to Replace Speakers, Removal and Install 4.1) Remove exposed screw.
How to Install Speakers, Removing and Replacing 5.1) Gently pull top edge of small panel from door releasing clips.
How to Replace Speakers, Removal and Install 6.1) Pull panel straight up to release bottom hook from behind door panel.
How to Install Speakers, Removing and Replacing 7.1) Roll window down and remember window handle position for installing.
How to Replace Speakers, Removal and Install

8.1) There is a special tool for removing door handle clips. Most mechanics do not own one. There is a door handle and a small plastic washer. There are two other ways to attempt the removal.

How to Install Speakers, Removing and Replacing 9.1) Place a shop rag between door handle and washer. Pull shop rag up and down to wedge into opening. This may release the clip.
How to Replace Speakers, Removal and Install 10.1) If you are unable to release the clip in the above step, here is a second way to remove.
How to Install Speakers, Removing and Replacing 11.1) Push the door panel in along with the washer, this will allow you to look down the edge of the door and see the clip.
How to Replace Speakers, Removal and Install 12.1) With a pick tool, hook the door handle clip and pull to release.
How to Install Speakers, Removing and Replacing 13.1) Remove door handle and washer. Don't forget to install washer when reassembling.
How to Replace Speakers, Removal and Install 14.1) Removed door handle and clip.
How to Install Speakers, Removing and Replacing 15.1) Immediately place clip onto door handle. Door handle can be snapped back onto shaft when reinstalling. Don't forget the original position of the handle.
How to Replace Speakers, Removal and Install 16.1) Gently pry trim ring from door open handle.
How to Install Speakers, Removing and Replacing 17.1) Work your way around trim panel to release all clips.
How to Replace Speakers, Removal and Install 18.1) Remove trim panel, look closely, this panel fits one way only.
How to Install Speakers, Removing and Replacing 19.1) Starting at bottom of door panel gently pry door panel from door releasing all clips.
19.2) Work your way up the front and back of door panel releasing remaining clips.
How to Replace Speakers, Removal and Install 20.1) Lift back edge of door panel up out of window jam and over door lock pin.
20.2) Lift front edge of door panel up out of widow jam and remove panel.
How to Install Speakers, Removing and Replacing 21.1) Remove four screws securing speaker to door.
How to Replace Speakers, Removal and Install 22.1) Check door for any door panel pins that were not removed with door panel.
22.2) Pry door panel pins from door.
How to Install Speakers, Removing and Replacing 23.1) Reinstall door panel pins to missing locations.
How to Replace Speakers, Removal and Install 24.1) When reinstalling door panel, rubber grommet at door lock pin may pop off. Lift back edge of door panel up to reinstall and guide gently down over door lock.
How to Install Speakers, Removing and Replacing 25.1) Remember trim ring from door open handle, align and snap back into position.
   
Chevrolet Aveo Rear Speaker Removal and Replacement
Car Stereo Repair
| Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
Installing Speakers, with Removal and Replacement

Chevrolet Aveo
How to Remove and Install Rear Speakers

Replacing Speakers, with Removal  and Installation 1.1) Open trunk for access.
1.2) Disconnect leads at both speakers.
Installing Speakers, with Removal and Replacement 2.1) Look for center brake light wire harness.
Replacing Speakers, with Removal  and Installation 3.1) Release trigger on connector at center brake light.
Installing Speakers, with Removal and Replacement 4.1) Lower rear seat backs.
4.2) From rear deck, squeeze sides of cover at child seat lock downs.
Replacing Speakers, with Removal  and Installation 5.1) Lift cover.
Installing Speakers, with Removal and Replacement 6.1) Remove bolt from child seat lock down.
Replacing Speakers, with Removal  and Installation 7.1) Remove child seat lock down assembly.
Installing Speakers, with Removal and Replacement 8.1) Remove spacer.
8.2) Repeat for all child seat lock downs.
Replacing Speakers, with Removal  and Installation 9.1) Gently pry under rear deck.
Installing Speakers, with Removal and Replacement 10.1) This will release clip without bending the plastic sides of the clip.
Replacing Speakers, with Removal  and Installation 11.1) Repeat for all clips along the edge of the rear deck panel.
Installing Speakers, with Removal and Replacement 12.1) Gently lift center of rear deck panel up.
Replacing Speakers, with Removal  and Installation 13.1) Release both sides of rear deck panel from behind edge of side panel.
Installing Speakers, with Removal and Replacement 14.1) Pull entire rear deck panel toward front seats.
Replacing Speakers, with Removal  and Installation 15.1) Pull to allow access to rear deck speakers. Seat belt straps will remain in place. Lay rear deck down in place of upright rear seat backs.
Installing Speakers, with Removal and Replacement 16.1) Remove screws securing speakers to rear deck.
   
Chevrolet Aveo - Wire Diagrams - Wire Color Codes
Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
 
Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn.
DO NOT CUT FACTORY WIRE HARNESS
   
Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above.
We discourage cutting the factory wire harness.
This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons.
Diagrams may not be applicable to Bose Audio Systems
   
1978 - 1992
IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts.
Car Stereo Wire Color Codes and Wire Diagrams Wire color codes and connector pin outs
1   Black Ground
2   Gray Dimmer
3   or Blank Antenna/Amplifier Trigger On
4   Yellow Switched +12 volts
5   Light Green Right Front Speaker (+)
6   Tan Left Front Speaker (+)
7   Gray Left Front Speaker (-)
8   Dark Green Right Front Speaker (-)
9   Brown Left Rear Speaker (+)
10   Dark Blue Right Rear Speaker (+)
11   Light Blue Right Rear Speaker (-)
12   Yellow Left Rear Speaker (-)
    Factory Wire Harness On Factory Car Stereo  
13     Orange Orange Constant +12 Volts
14     Brown Brown Illumination

Corvette Only with Second One Wire Black Connector

15       Pink Bose Amplifier Trigger On
   
1988 - 2005
GM Wire Harness Diagram, Wire Color Codes and Pin Configuration Wire color codes and wire diagrams
IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts.
1   Gray Left Front Speaker (-)
2   Tan Left Front Speaker (+)
3   Dark Green Right Front Speaker (-)
4   Light Green Right Front Speaker (+)
5   Black Ground
6   Brown Illumination
7   Gray Dimmer
8   Blank  
9   Yellow* (Green) Switched +12 volts
10   Orange Constant +12 volts
11   Light Blue Right Rear Speaker (-)
12   Dark Blue Right Rear Speaker (+)
13   Yellow Left Rear Speaker (-)
14   Brown Left Rear Speaker (+)
   
Wire Codes and Pin Lay Out on Back of Factory Car Stereo

Wire color codes, wire diagrams, connectors and configuration
Note the location of the connector "Keys" in yellow.

 

1 Ground
2 Right Front Speaker (+)
3 Right Front Speaker (-)
4 Left Rear Speaker (-)
5 Left Rear Speaker (+)
6  
7  
8  
9  
10  
11  
12  
13 Illumination
14 Right Rear Speaker (+)
15 Right Rear Speaker (-)
16 Left Rear Speaker (-)
17 Left Rear Speaker (+)
18  
19  
20  
21 Dimmer
22  
23 Switched +12 Volts
24 Constant +12 Volts
   
All wire diagrams and color codes are not 100% accurate.
   

Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us

Factory Car Stereo Repair, Inc.
1987 Corporate Square, Suite 159
Longwood, Fl. 32750