Chevrolet Blazer / S-10 Pickup Car Stereo Removal Guide
 

Chevrolet Blazer / S-10 Pickup
How to Remove and Install Car Stereo Instructions

1.1) Remove ash tray.
1.2) Remove one exposed screw at left bottom side of car stereo.
2.1) Open glove box and remove two exposed screws along right side of car stereo.
3.1) Pull bottom edge of car stereo trim panel away from dash and down to release top latches.
3.2) Disconnect connectors at lighter and set car stereo trim panel to side.
4.1) Remove two exposed screws, one on each side of car stereo.
4.2) Pull car stereo forward, disconnect antenna and connectors.
   
Front and Rear Speaker Removal presently not available.
   
Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up
   
NO AUDIO
With aftermarket stereo installation?
   
Erratic Volume Control
DIY Repair
   

Car Stereo Repair Home | Car Stereo Removal | FAQ | Contact US

Factory Car Stereo Repair, Inc.
1987 Corporate Square, Suite 159
Longwood, Fl. 32750