Dodge Ram Car Stereo and Speaker Replacement

   
Dodge Ram Factory Car Stereo Removal

Must have pocket below car stereo that opens.
   
Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up
   
NO AUDIO
With aftermarket stereo installation
   
Dodge Ram Front Speaker Removal
1.1) At top front edge of door panel, remove screw at opening.
2.1) Look into opening at door open handle for door handle mounting bolt.
3.1) Remove 11 mm bolt.
4.1) Remove door handle and set to side.
5.1) With door handle removed remove screw at opening on door panel.
6.1) Along bottom front edge of door panel, remove screw.
7.1) Along bottom back edge of door panel, remove screw.
8.1) To remove door panel, tap up on bottom of panel. Panel will move upwards.
9.1) Lift back edge of door panel up over door lock out of window jam.
10.1) Back of door panel has hooks along edges.

11.1) Hooks mate to slots on door panel.

Note - Lifting panel up releases hooks from slots. Pushing door panel down locks door panel into place.

12.1) Pull top edge of door panel back for access to back of panel.
13.1) Locate wires from door to window and door lock control panel.
14.1) Squeeze trigger on connector into connector to release lock.
15.1) Remove connector.
16.1) Squeeze trigger on second connector into connector to release lock.

17.1) Remove connector.
17.2 Remove door panel and set to side.

Note 1 - Passenger's door may have less connectors.
Note 2 - Courtesy light may also be attached to door panel, twist light base to release from door panel and remove.

18.1) Remove screws securing speaker to door. Remove and disconnect.

19.1) When reinstalling door panel, align door lock with opening in door panel.

Note - Hooks along bottom of door panel are longest and should be aligned first before aligning remaining hooks and pushing panel down to lock into place.

   
Dodge Ram Rear Speaker Removal

Dodge Ram Speaker Removal
1.1) Look into opening at door open handle for door handle mounting bolt.
2.1) Remove 11 mm bolt.
3.1) Remove door handle and set to side.
4.1) With door handle removed remove screw at opening on door panel.
5.1) To remove door panel, tap up on bottom of panel. Panel will move upwards.
6.1) Lift door panel up over door lock and out of window jam.
7.1) Pull top edge of door panel back for access to back of panel.
8.1) Locate wires from door to window and door lock control panel..
8.2) Squeeze trigger on connector into connector to release lock.
9.1) Remove connector.
9.2 Remove door panel and set to side.
10.1) Back of door panel has hooks along edges.

11.1) Hooks mate to slots on door panel.

Note - Lifting panel up releases hooks from slots. Pushing door panel down locks door panel into place.

12.1) Remove screws securing speaker to door. Remove and disconnect.
13.1) When reinstalling door panel, align door lock with opening in door panel.
14.1) Hooks along bottom of door panel are longest and should be aligned first before aligning remaining hooks and pushing panel down to lock into place.
   

Car Stereo Repair Home | Car Stereo Removal | FAQ | Contact US

Factory Car Stereo Repair, Inc.
1987 Corporate Square, Suite 159
Longwood, Fl. 32750