 |
for Access to Display Module and Clock Assembly |
 |
1.1) Pry edge of small insignia labeled panel from dash releasing clips. All clips release with pry pressure. |
 |
2.1) Remove small panel and set to side. |
 |
3.1) Remove exposed screw. |
 |
4.1) Pry edge of small security labeled panel from dash releasing clips. |
 |
5.1) Panel is attached, pull slightly from opening. |
 |
6.1) Hold panel to side, remove exposed screw. |
 |
7.1) Pry bottom left edge of entire panel from dash releasing clips. |
 |
8.1) Pry along bottom of panel releasing clips. |
 |
9.1) Pry up along right side of panel releasing clips. |
 |
10.1) Pry up along left side of panel releasing clips. |
 |
11.1) Release all clips and pull entire panel from dash. |
 |
12.1) Locate connectors to panel. |
 |
13.1) Squeeze trigger on connector into connector to release lock. |
 |
14.1) Remove connector. 14.2) Repeat steps 12-14 for remaining connectors. |
 |
15.1) Remove panel and set to side. |
 |
16.1) Remove screws securing display module, release connectors to remove. 16.2) Clock is secured inside opening at bottom. |
If you have found this page to be helpful, please |
|