|Mitsubishi Montero Car Stereo - Car Radio Removal|
|1.1) Remove two covers.
1.2) Remove six screws.
1.3) Pull panel forward and release to floor.
|2.1) Remove two exposed screws left side of front dash panel.|
|3.1) Open glove box and remove one exposed screw.|
|4.1) Along panel on passenger side of car, two clips. Push center pin in, remove these two panel clips
4.2) Drop panel slightly.
*Note - To reinsert these panel clips, center pin must be pushed back through housing, inserted clip into opening, push center pin flush to housing to lock.
|5.1) Remove one exposed screw.|
|6.1) Remove ash tray.
6.2) Remove two screws in ash tray cavity.
|7.1) Remove ash tray holder from cavity, twist lamp base from holder and set holder to side.|
|8.1) Pull AC vent and trim slightly away from dash, there are two screw that are located above the gauges so do not remove this panel.|
|9.1) Set parking brake and shift to low gear.
9.2) With panel loose from above step, remove trim from around car stereo watching stereos trims upper lip clears from behind above panel.
|10.1) Remove four screws securing
car stereo to dash.
10.2) Pull car stereo forward releasing antenna and connector.
Installing Aftermarket Speakers and Proper Hook-up
With aftermarket stereo installation?
|Erratic Volume Control
Front Door Panel with Speaker Removal and Installation
|When payment is complete at Paypal, click on "Return to Car Stereo Removal, LLC" for direct access to instructions. Also, check your In Box/Junk Mail folder for email from No-Replay@carstereoremoval.com with subject "User and Password for Carstereoremoval.com" for access.|
|Rear Speaker Removal presently not available.|
Factory Car Stereo Repair, Inc.