Oldsmobile Intrigue Removing and Installing Car Radio
Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
   
How to Remove Car Stereo, Installation and Replacement

Oldsmobile Intrigue
Car Stereo Removal and Installation

How to Remove Car Stereo, Installation and Replacement 1.1) Lift arm rest and remove two screws securing center console.
1.2) Lift panel up releasing four clips. All clips release with pressure. Be careful to notice if clips remain with panel or in their mounting slot.
1.3) Remove panel over gear shift.
How to Remove Car Stereo, Installation and Replacement 2.1) Remove trim panel from around car stereo releasing four clips and set aside. Be careful to notice if clips remain with panel or in their mounting slot.
How to Remove Car Stereo, Installation and Replacement 3.1) Remove three screw securing car stereo to dash.
3.2) Pull car stereo forward from dash.
3.3) Remove antenna and release trigger on connectors to disconnect.
   
Factory Wire Color Codes
See Diagrams Below
   
Aftermarket Wire Color Codes
See Diagrams Below
   

Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up

Speaker Phasing
Font Left   Front Right
+ Tan   + Light green
- Gray   - Dark green
     
Rear Left   Rear Right
+ Brown   + Dark blue
- Yellow   - Light blue
   
NO AUDIO
With aftermarket stereo installation?
   
Erratic Volume Control
DIY Repair
   
Oldsmobile Intrigue Removing and Installing Speakers
Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
Stereo Removal Oldsmobile Intrigue, Replace and Install

Oldsmobile Intrigue Front Door Speaker Removal and Installation

Stereo Removal Oldsmobile Intrigue, Replace and Install 1.1) Remove one torx screw from door panel.
Stereo Removal Oldsmobile Intrigue, Replace and Install 2.1) Pry panel from inside door opener.
Stereo Removal Oldsmobile Intrigue, Replace and Install 3.1) Removed one exposed screw from panel removal.
3.2) Remove panel, disconnect connector and set to side.
Stereo Removal Oldsmobile Intrigue, Replace and Install 4.1) Lift control panel releasing clips.
4.2) Remove connector from panel and set to side.
4.3) Remove one exposed torx screw from panel removal.
Stereo Removal Oldsmobile Intrigue, Replace and Install 5.1) Pull door panel from door releasing 12 clips.
Stereo Removal Oldsmobile Intrigue, Replace and Install 6.1) Disconnect connector for tweeter.
Stereo Removal Oldsmobile Intrigue, Replace and Install 7.1) Remove four screws securing speaker to door panel.
   
Oldsmobile Intrigue Rear Speaker Removal and Install
Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
How to Replace Speakers, Removal and Installation

Oldsmobile Intrigue How to Remove and Replace Rear Deck Speakers

How to Replace Speakers, Removal and Installation 1.1) Pull two rings, one each at bottom of rear seat bottom cushion.
1.2) Lift rear seat from front of cushion and remove.
How to Replace Speakers, Removal and Installation 2.1) Remove bolts at bottom of rear seat back cushion securing seat belts and rear back seat cushion.
How to Replace Speakers, Removal and Installation 3.1) From trunk, release rear seat release switch freeing cable.
How to Replace Speakers, Removal and Installation 4.1) Pull rear seat backs down.
4.2) Remove four screws securing rear seat locks.
4.3) Pull rear seat frame from back of car forward.
How to Replace Speakers, Removal and Installation 5.1) Release three clips along front edge of package shelf cover.
How to Replace Speakers, Removal and Installation 6.1) Feed seat belt strap through slit in panel.
How to Replace Speakers, Removal and Installation 7.1) Push down on both sides of package shelf panel releasing clip guides from side panels.
7.2) Pull rear package shelf panel toward front of car.
How to Replace Speakers, Removal and Installation 8.1) Four screws secure each 6" X 9" speaker to rear deck.
   
Oldsmobile Intrigue Wire Diagrams and Wire Color Codes
Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us
 
Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn.
DO NOT CUT FACTORY WIRE HARNESS
   
Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above.
We discourage cutting the factory wire harness.
This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons.
Diagrams may not be applicable to Bose Audio Systems
   
GM Wire Harness Diagram, Wire Color Codes and Pin Configuration Wire color codes and wire diagrams
IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts.
1   Gray Left Front Speaker (-)
2   Tan Left Front Speaker (+)
3   Dark Green Right Front Speaker (-)
4   Light Green Right Front Speaker (+)
5   Black Ground
6   Brown Illumination
7   Gray Dimmer
8   Blank  
9   Yellow* (Green) Switched +12 volts
10   Orange Constant +12 volts
11   Light Blue Right Rear Speaker (-)
12   Dark Blue Right Rear Speaker (+)
13   Yellow Left Rear Speaker (-)
14   Brown Left Rear Speaker (+)
   
All wire diagrams and color codes are not 100% accurate.
   

Car Stereo Repair | Car Stereo Removal | FAQ | Shipping for Repair | Contact Us

Factory Car Stereo Repair, Inc.
1987 Corporate Square, Suite 159
Longwood, Fl. 32750