|MR2 / Spyder Car Audio - Car Radio and Speaker Removal|
Toyota MR2 Spyder Car Stereo Removal Instructions
NOTE - Yes, this is an aftermarket car stereo. Removal instructions will apply.
|1.1) From bottom of each side of car stereo, side rails, pull plastic cover from mount.|
|2.1) Remove two exposed screws from each side of dash.|
|3.1) Pull bottom edge of panel away from dash.|
|4.1) Push side panel slightly up then down to release.|
|5.1) Remove lower screw from each side of car stereo.|
|6.1) Remove upper screw from
each side of car stereo.
6.2) Pull car stereo from dash, disconnect antenna and release trigger on connectors to disconnect.
|Aftermarket Car Stereo Installation|
|Aftermarket Car Stereo
Wire Color Codes
|Factory Wire Harness, Color Codes and Aftermarket Installation|
Installing Aftermarket Speakers and Proper Hook-up
With aftermarket stereo installation?
|Erratic Volume Control
Factory Car Stereo Repair, Inc.